Loepfe WeftMaster CUT-iT - Troubleshooting; Warnings

Troubleshooting
WeftMaster CUT-iT
www.loepfe.com 25
5 Troubleshooting
5.1 Warnings
A warning is displayed for 3 seconds:
Warning Display Action
1
«NOT POSSIBLE!» Operator cannot execute
(e.g. select program while machine is run-
ning)
Select a program when the weaving ma-
chine is idle.
2
«BOOST LIMITED»
The boost current strength is limited for an
output power of max. 325 W.
When the boost current strength limit is
reached, the boost time is extended.
3
«RUN LIMITED»
The run current strength is limited for an
output power of max. 125 W.
The run current strength is limited.