Loepfe WeftMaster CUT-iT - Page 22

Operation
22 www.loepfe.com
WeftMaster CUT-iT
3.
Press to confirm process.
ð Display: «Tune-Run» (setting in Run mode)
4. Press to select desired setting.
5. If no button is pressed within 10 seconds.
ð Setting mode is exited without saving any changes.
6.
Press to confirm desired setting.
ð Display: «Execute» (execute)
ð The setting is saved.
Run current strength with machine running
Only the run current strength can be set when the weaving machine is running.
ü The weaving machine is running.
1.
Press for 3 seconds.
ð Display: «Tune-Run» (setting in Run mode)
2. Press to select desired setting.
3. If no button is pressed within 10 seconds.
ð Setting mode is exited without saving any changes.
4.
Press to confirm desired current strength.
ð Display: «Execute» (execute)
ð The setting is saved.