Connect ID 40-55 DR+
User guide
103
Automatic update via the internet
At the end of the initial installation, Information on new software
updates was selected.
This item cannot be called up via the menu, but appears automati-
cally when a new version is found in the search for software.
New software package found
If the TV set has found a new software version during the check, you
will be informed about this via a screen message.
Select the desired procedure.
Load the
software
now
After confirmation, the new TV software will be
loaded from the internet and then programmed.
Load the
software
when
switch off to
standby
The software will be loaded and programmed after
the TV set has been switched off into standby mode
for the next time. The display on the control panel
will light up blue during the update.
The TV set must not be switched off at the mains
before the downloading process is complete (control
panel display lights up white)!
Load the
software
later (at
most
three-fold
notification)
Loading the software will be postponed to a later date.
The new software message will be displayed the next
time the TV set is switched on.
If the loading process is postponed three times then
the message will only be shown again once the next
software version is available.
Do not
load this
software
version
The new software will not be loaded. The on-screen
message will only be shown again for the next soft-
ware version.
Confirm selection.
A new software version was found.
New software: V2.1.27.0 (Freeman Boot FRC FRCW1 STB WLAN FEA)
(Current software V2.1.25.0)
Please specify how you would like to continue:
Load the software now
Load software when switching off to standby
Load software later (max. 3 times notification)
Do not load this software version
New software
System settings
Control
To Next Page
Loading...
Need help?
General