131 -
english
Programming the timer with the timer overview
All programmed recordings, marked programmes and copy orders are listed
in the timer overview. You can also programme new recordings, mark other
programmes and copy pre-recorded programmes from the DR archive to
an external recorder with the timer overview.
Call DR archive.
Red button: Call Timer list.
Red button: New entry (see right hand column).
Green button: Change recording.
Yellow button: Delete recording.
Blue button: Delete memo.
Explanation of the symbols in the timer list:
Record
۰ Repeated recording (daily, weekly or Mon-Fri)
ܱ Serial recording
Decoding order (later decoding of an encrypted recorded
programme)
۪ Marked programme (see page 56)
New entry: Programme timer recording manually
➠ Timer list is opened.
Red button: Call New timer entry.
Select Recording,
OK call.
Select Manual.
For programming a timer recording Via EPG or Via
Teletext see page 130.
OK Call Station selection.
Select station.
OK Call Timer data.
Entry of the timer data see page 130.
After confirming the timer data the new recording is
transferred to the timer overview.
New entry: Memorize programme using the timer overview
➠ Timer list is opened.
Red button: Call New timer entry.
Select Memo.
OK EPG is opened.
Note desired programme as described in Switching and
memorizing with the programme list (page 56).
New entry: Copying DR archive entries
➠ Timer list is opened.
➠ An external recorder is registered.
Red button: Call New timer entry.
Select Copy.
OK The DR archive is opened.
See the chapter Copying recordings (pages 106 and 107)
for further steps.
7,0(5/,67 0RQ
0RQ 'DV(UVWH ۪%ULVDQW
7XH'5)X¡EDOOOLYH
۰57/8QWHUXQV
ܱ=')KHXWH
7XHVDWZLVVHQVSH]LDO
:HG '5ט$9 :HOWGHU:XQGHU
'HOHWHUHFRUGLQJ1HZHQWU\
&KDQJHUHFRUGLQJ
Memo Copy
NEW TIMER ENTRY
Recording
OK
Via teletext Manual
RECORDING WIZARD
Via EPG
OK
Copy
NEW TIMER ENTRY
Memo
OK
Rec
To Next Page
Loading...
Need help?
General