LOGICDATA DMP360 User Manual

DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 15
Other tables:
3. Plug the Actuators into the Benching Adapter
4. Plug the User Interface into the Benching Adapter
5. Plug the Benching Adapter into the Power Hub or sequential Benching Adapter
6. If a Power Hub is used, plug the Power Hub into the Mains
INFO A maximum of 6 tables (table 1 plus 5 others) can form a Benching System. For
Benching Systems with more than 2 tables, repeat steps 3 to 5 for each table.
NOTICE Only one type of DYNAMIC MOTION Actuator can be used per Table within the
Benching System. Multiple types of Actuator can be used in the system (e.g.
DMD500 in Table 1 and DMG90 in Table 2. However, connecting dierent types
of Actuator within a Benching System may cause errors and damage to the Table
System if performed incorrectly. Contact LOGICDATA before attempting to cre-
ate a Benching System of this type.
4.3.3 COMPLETING ASSEMBLY
Before you use the table, you must perform a Position Reset Procedure (see Chapter 4.7 page 18).

LOGICDATA DMP360 Specifications

General

Brand	LOGICDATA
Model	DMP360
Category	Control Systems
Language	English