DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 20
5.2 STANDARD FUNCTIONS
This section describes functions that can be performed using both Comfort and Basic User Handsets along-
side the DYNAMIC MOTION system. If your DYNAMIC MOTION system will be controlled by a dierent User
Interface, consult that product's Operating Manual for instructions and safety advice.
5.2.1 ADJUSTING THE TABLE TOP HEIGHT
CAUTION
Risk of minor or moderate injury through crushing
Your ngers may be crushed when you attempt to change the height of the table
• Keep ngers away from moving parts
• Ensure that no persons or objects are in the table's range of motion
INFO The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
ned stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached
5.3 ADVANCED FUNCTIONS
This section describes functions that can only be performed using Comfort User Handsets alongside
the DYNAMIC MOTION system. If your DYNAMIC MOTION system will be controlled by a dierent User
Interface, consult that product's Operating Manual for instructions and safety advice.
5.3.1 SAVING A MEMORY POSITION
This function saves a set Table Top position. One Memory Position can be saved per Memory Position Key.
1. Move the table to the desired height (Chapter 5.1.1, Adjusting the Table Top height)
The display shows the Table Top height (e.g. 73 cm)
2. Press the SAVE Key.
3. Press the Memory Position Key (e.g. 2)
The display shows S 2
After about two seconds, the Table Top height is displayed again
SAVE
2
To Next Page
Loading...
Need help?
General
