SMARTNEO - OPERATING MANUAL // PAGE 24
The display shows S and a number (e.g. S 4)
Press the DOWN Key until the display shows S 0.
The display shows S 0.
Press the SAVE Key.
The SMARTneo-2G has now been reset to its factory settings. It is now in the same
state as it was during the rst start-up.
8.4 CONTAINER STOP AND SHELF STOP POSITIONS
These features can limit the movement area of the Table Top (if e.g. a container is below the table or a shelf
is above it). Container Stop Positions become the new lowest end position, Shelf Stop Positions the highest.
INFO
Container Stop Positions can only be saved only in the lower half of the movement
area, Shelf Stop Positions in the upper half. You must set each position separately.
8.4.1 USING A BASIC HAND CONTROL
To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position
Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is saved (Container Stop if you are in
the bottom half of the movement area, Shelf Stop if you are in the top half).
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is deleted (Container Stop if you are
in the bottom half of the movement area, Shelf Stop if you are in the top half).
8.4.2 USING A COMFORT HAND CONTROL
To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position
SAVE
2. Press and hold the SAVE Key for 10 seconds
▸ The Control Box will click twice.
▸ The Container Stop / Shelf Stop Position is saved
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a
Shelf Stop Position) or bottom half (Container Stop Position) of the movement
area.
S 4
S O
SAVE
To Next Page
Loading...
Need help?
General
