SMARTNEO - OPERATING MANUAL // PAGE 6
2 SAFETY
2.1 TARGET AUDIENCE
This manual is intended for Skilled Persons only. Refer to Chapter 2.8, Skilled Persons on page 9 to ensure
that personnel meet all requirements.
2.2 GENERAL SAFETY REGULATIONS
In general, the following safety regulations and obligations apply when handling the product:
• Do not operate the SMARTneo-2G unless it is in a clean and perfect condition
• Do not remove, change, bridge, or bypass any protection, safety, or monitoring equipment
• Do not convert or modify any components without written approval from LOGICDATA
• In the event of malfunction or damage, any faulty components must be replaced immediately
• Unauthorized repairs are prohibited
• Do not attempt to replace hardware unless the system is in a de-energized state
• Only skilled persons are allowed to work on the SMARTneo-2G
• Ensure that national worker protection conditions and national safety and accident prevention
regulations are observed during operation of the system
2.3 INTENDED USE
The SMARTneo-2G is a Control Box for electrically Height-Adjustable Tables. It is intended for indoor use
only. The system may only be installed in compatible Height-Adjustable Tables and with LOGICDATA-
approved accessories. Contact LOGICDATA for further details. Use beyond or outside the intended use will
void the product’s warranty. Please refer to the Operating Manual of each product in the Table System to
determine its individual intended use.
The installation site must be level, vibration-free, and free from contamination. It must be ensured that there
is no extraordinary exposure through dust, toxic or caustic gases and vapours, or through inadmissible heat
exposure at the installation site.
2.4 REASONABLY FORESEEABLE MISUSE
Usage outside of the intended use of the SMARTneo-2G could lead to minor injuries, serious injuries, or even
death. Reasonably foreseeable misuse of the system includes, but does not extend to:
• Using the system as a climbing or lifting aid for people or animals
• Connecting unauthorized products to the SMARTneo-2G. If you are unsure as to whether a
product can be used with the SMARTneo-2G, contact LOGICDATA for further information
• Overloading the Table System
To Next Page
Loading...
Need help?
General
