SMARTNEO - OPERATING MANUAL // PAGE 9
CAUTION Risk of minor or moderate injury through crushing
If any Hand Control Key becomes stuck while the system is in motion, the system may
not stop properly. This may lead to minor or moderate injury through crushing.
• Disconnect the system immediately if any Hand Control Key becomes stuck
CAUTION Risk of minor or moderate injury through tripping
During the assembly process, you may have to step over Cables. Tripping over Cables
may lead to minor or moderate injury.
• Ensure that the assembly area is kept clear of unnecessary obstructions
• Be careful not to trip over Cables
CAUTION This appliance can be used by children from 8 years and above and people with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children must not play with the appliance.
Cleaning and maintenance by the user must not be performed by children, unless they
are over 8 years old and supervised.
2.8 SKILLED PERSONS
CAUTION Risk of injury through incorrect installation
Only Skilled Persons have the expertise to complete the installation process safely.
Installation by unskilled persons can lead to minor or moderate personal injury.
• Ensure that only Skilled Persons are allowed to complete the installation
• Ensure that persons with limited ability to react to danger do not take part in the
assembly process
The table system may only be assembled by Skilled Persons. A Skilled Person is dened as someone who:
• Is authorized for installation planning, installation, commissioning, or maintenance/servicing
of the product
• Has read and understood the Table System documentation, as well as the documentation rele-
vant to the component products of the system
• Has the technical education, training, and/or experience to perceive risks and avoid hazards
• Has knowledge of the specialist standards applicable to the product
• Has the expertise to test, assess, and manage electrical and mechatronic products and systems
in accordance with the generally accepted standards and guidelines of electrical engineering
and furniture manufacturing
To Next Page
Loading...
Need help?
General
