SMARTNEO - OPERATING MANUAL // PAGE 23
8 SOFTWARE-DEPENDENT
FUNCTIONS
8.1 LOW SPEED AREA
During movement, this function causes a reduction in speed before the following positions are reached:
• Maximum and minimum Table Top height
• All saved positions (e.g. Memory Positions, Container Stop Position)
CAUTION
Risk of minor or moderate injury through crushing
Collision Detection (ISP) is inactive in the Low Speed Area. This may lead to minor or
moderate injury through crushing.
• Ensure that no persons or objects are in the table's range of motion
8.2 SAFETY AREA
This function causes a safety stop at a dened Table Top height, which is set through the product's software.
INFO You cannot save table positions that fall within the safety area.
CAUTION
Risk of minor or moderate injury through crushing
Collision Detection (ISP) is inactive in the Safety Area. This may lead to minor or mod-
erate injury through crushing.
• Ensure that no persons or objects are in the table's range of motion
Press and hold the DOWN Key
▸ The Table Top is adjusted to the start of the Safety Area
▸ The Table Top stops moving when the Safety Area is reached
Press the DOWN Key again to move into the Safety Area
8.3 FACTORY RESET (S0 RESET)
With this function, you can reset the SMARTneo-2G to its factory settings.
8.3.1 USING A BASIC HAND CONTROL
Disconnect the Control Box from the mains.
While disconnected, press and hold the UP and DOWN Keys
Reconnect the Control Box. Hold the Keys until the Control Box clicks twice per second.
Release the UP and DOWN Keys
The SMARTneo-2G has now been reset to its factory settings. It is now in the same state
as it was during the rst start-up.
8.3.2 USING A COMFORT HAND CONTROL
1 2
Press and hold the following Keys for 3 seconds:
• Memory Position Keys 1 and 2
• UP Key
To Next Page
Loading...
Need help?
General
