LOGICDATA SMARTneo-2G - Correcting the Height Display; Changing the Displayed Unit of Measurement; Duty Cycle Monitoring

SMARTNEO - OPERATING MANUAL // PAGE 25
SAVE
2. Press and hold the SAVE Key for 10 seconds
▸ The Control Box will click once.
▸ The Container Stop / Shelf Stop Position is deleted
8.5 CORRECTING THE HEIGHT DISPLAY
This feature changes the height displayed on the Hand Control. It does not aect the table's actual height.
SAVE
1. Press the SAVE Key.
5
-
▸ The display shows S –.
2. Press and hold the DOWN Key for approximately 5 seconds.
o73
▸ The display starts to ash.
3. Use the UP Key or DOWN Key to set the new height
SAVE
4. Press the SAVE Key.
7 3
▸ The height display is now set to the new Table Top height.
8.6 CHANGING THE DISPLAYED UNIT OF
MEASUREMENT (CM / INCH)
Comfort Hand Controls can display the height of the Table Top in both centimeters and inches. To change the
displayed unit of measurement:
1 2
Press and hold the following Keys for 3 seconds:
• Memory Position Keys 1 and 2
• UP Key
▸ The display shows S and a number, e.g. S 7.
2. Press the button UP Key until the display shows S 5.
▸ The display shows S 5.
3. Press the SAVE Key
▸ If the display was previously set to cm, it is now set to inches.
▸ If the display was previously set to inches, it is now set to cm.
8.7 DUTY CYCLE MONITORING
Duty Cycle Monitoring causes a system shutdown when the maximum Duty Cycle is reached. The Duty Cycle
limits can be found in the product's Datasheet.
5
-
s 5
SAVE