14
CONTROL FUNCTION
3 in 1 switch knob
① Engine switch \fuel valve “OFF”;
Ignition circuit is switched off. Fuel is switched off.
The engine will not run.
② Engine switch \fuel valve \ chock “ON”
Ignition circuit is switched on. Fuel is
switched on. chock is switched on.
The engine can be running.
③ Engine switch \fuel valve \ chock “ON”
Ignition circuit is switched on. Fuel is
switched on. chock is switched off.
The engine can be start
.
TIP: The chock“ ” is not required to start a
warm engine.
Oil warning light (red)
When the oil level falls below the lower level,
the oil warning light comes on and then the
engine stops automatically. Unless you refill
with oil, the engine will not start again.
Tip: If the engine stalls or does not start, turn
the engine switch to “ON” and then pull the
recoil starter.
If the oil warning light flickers for a few seconds,
the engine oil is insufficient. Add oil and restart.
Overload indicator light (Red)
The overload indicator light comes on when
an overload of a connected electrical device is
detected, the inverter control unit overheats, or
the AC output voltage rises. Then, the AC
protector will trip, stopping power generation in
order to protect the generator and any connected
To Next Page
Loading...
