33
adjusted specification.
5. Install the spark plug.
TIP
If a torque wrench is not available when
installing a spark plug, a good estimate of the
correct torque is 1/4-1/2 turn past finger tight.
However, the spark plug should be tightened to
the specified torque as soon as possible.
6. Install the spark plug cap and spark plug cover.
Carburetor adjustment
The carburetor is a vital part of the engine. Adjusting should be left to a
LONCIN dealer with the professional knowledge, specialized date, and
equipment to do so properly
.
Engine oil replacement
Avoid draining the engine oil immediately after stopping the engine. The
oil is hot and should be handled with care to avoid burns.
1. Place the generator on a level surface
and warm up the engine for several
minutes. The stop the engine and turn the
3 in 1 switch knob,fuel tank cap air vent
knob to “OFF”.
2. Remove the screws and then remove
the cover.
3. Remove the oil filler cap .
Spark Plug Torque:
20.0 N*m (2.0kgf*m, 14.8 lbf*ft)
To Next Page
Loading...
Need help?
General
