SECTION 4. DISASSEMBLY AND SERVICE
3) CRANKPIN O.D.
Standard Service limit
21.985 mm 21.925 mm
4) CONNECTING ROD BIG END SIDE CLEARANCE
5) CONNECTING ROD BIG END OIL CLEARANCE (RADIAL)
a) Clean all oil from crank pin surface.
b) Place a piece of plastigauge, install connecting rod, and
tighten the bolts to the specified torque.
Tightening torque: 12-14N.m
Note: Do not rotate crankshaft when tightening the bolts.
c) Remove the connecting rod and measure the plastigauge.
d) If the clearance exceeds the service limit, replace the
connecting rod and recheck the clearance.
If clearance still exceeds service limit after using the new
connecting rod, lap the crank pin to recondition it, and use a
connecting rod smaller than the standard value.
Standard Service limit
0. 1-0.7mm 1.1mm
Standard Service limit
0.04-0.063 mm 0.12 mm
- 24 -
To Next Page
Loading...
