1 Put ignition key on position of “ “.
2 Put emergency switch on position of “ ”.
5 Fuel valve is on position of “ ”.
1.Draw up choke lever on carburetor(Turn off choke
lever).
2.Turn 1/8 1/4 round of accelerator.
3.Start by electricity or foot.
4.Slightly turn greaser grip, speed up engine rotation
for heating.
5.Turn down choke lever when engine completely
heated,totally open choke valve.
.
.
.
3 Confirm neutral gear and its indicator is on.
4 Confirm fuel amount.
.
.
★ ：Engine's cold starting
～
No starting allowed before neutral gear confirmed,
or may lead to accident. Idle running is unnecessary
and bad for engine(especially in high speed).
★Caution:
12
Engine starting ★Engine turning off
1. Relax greaser grip, and slow down the engine.
2. Put on neutral position.
3. Lay ignition switch on position OFF
4. Fuel valve Fuel tank switch is on position“O”.（ ）
Engine running-in
No starting allowed in room with poor ventilation or without ventilators. Because the CO gas is a rank poison.
No leaving allowed when engine is under working status.
Warning:
The first 1000km is the running-in period.
In running-in period, please pay attention to these
issues below:
1. No heavy load and steep slope is allowed.
continuous driving more than 50km is not allowed.
3.No faster than 40km/h in the first 500km.is
allowed, the second 500km mileage should be no more
than 55km/h.
2.Pre-heating for 3 5 minutes before each
starting for sufficient lubrication for moving parts.
～
To Next Page
Loading...
Need help?
General