Recovery of using
1. Remove the covering cloth, and wipe up motorcycle, in case parking more than 4 months, replace lubricant.
2. Charge the battery and then install on motorcycle.
3. Drain off anti-rust liquid in fuel tank and then fully add fuel.
4. Carefully check motorcycle before driving, and make trial driving with low speed in safe place.
IX Introduction of electrical starting.
Electrical starting motorcycle is a designed and produced new model on the theoretical basis of foot starting engine with
improved electrical parts.
This model is for electrical starting only with battery specification of “12V7Ah”. Clutch lever switch for starting is installed on
left switch assembly and the engine could be started only when clutch is separated. Electrical starting button is equipped on right
switch assembly for starting engine. When starting, put the key of master switch on position “ON”, tightly hold clutch grip, and then
press down electrical starting button. In case starting failed in 5 seconds, release the switch, and re-start after seconds.
For your convenience of using and maintenance, please read the schematic diagram for electrical starting in the next page:
，
32
To Next Page
Loading...
Need help?
General