1 Open the seat
2 Clean up dust and corrosive impurity on the surface of battery.
3 Check joint of guiding line, in case corroded, please replace.
(1)When breaking down battery remove -pole first, and then +pole when installing
+pole first and then -pole no touch +pole on motorcycle is allowed.
(2)Electrolyte replacement is not allowed once battery is in using,and battery need to be
charged separately when power exhausted.
(3)Battery contains sulfuric acid contact with eyes or skin may lead to serious injury in case
did wash by pure water for 5 minutes and then send hospital
(4)Impurity enter battery is not allowed when at installing or breaking
(5) Make sure ventilation tube of battery is unobstructed.
. .
.
.
, （ ） （ ） ; ,
（ ） , （ ） （ ）
, ,
, .
.
,
Replacement of fuse
1. Iginition switch is on position of “OFF”. The replacing fuse should be with specification of (15A)
2. Open main seat, put fuse above of battery, alined, and then replace.
3. Immediate burnout after replacement indicates faults exist in other electrical equipment.
：
Checking of battery
No water washing battery is allowed. Fuse specification out of stipulation is not allowed, or it may seriously
damage electrical system even burn out motorcycle and make engine lose power, which is angerous.
26
Caution:
Warning:
Positive poleNegative pole
To Next Page
Loading...
Need help?
General