Long range MT4300-C - Page 13

Select Wobble Number
The MT4300-C can control up to 4 wobble
traps. Press the 1 button to assign the rst
wobble trap’s number.
Select Wobble #
1 4
to
3
4
Enter First Trap Number
To assign the rst wobble trap’s number, we
must know what trap numbers are assigned to
the wobble traps. If two wobble traps are traps
3 and 5, we enter the number 3. This assigns
trap 3 as wobble 1 on the MT4300-C unit.
Press ENTER.
Wobble 1
Trap = 3
Press Enter
Enter Remaining Wobble Numbers
The menu again asks for a wobble number.
Enter the next number, in this case 2, which
will take you to the trap number menu. Enter
the second wobble trap’s assigned trap
number, in this case 5, and press ENTER.
Continue this process till you have all (up to 4)
wobble trap numbers assigned.
Press BACK to Exit
Once all of the wobble traps are assigned,
press the BACK button to go back to the
Wobble Menu.
Wobble 2
Trap = 5
Press Enter
Wobble Menu
Wobble Control
Wobble Setup
1
2
5
6
11