Long range MT4300-C - Target Management Options; Super Sporting Trap Modes; Backlight Settings; Trap Status Diagnostics

4
5
6
Trap Modes
This option changes the number of traps you have on each station of Super Sporting. Choose
either 3 or 4 traps.
Back light
The screen on the MT4300-C has a back light which is useful for low lighting and night shooting.
With this option, you can turn it ON or O󰀨 or choose how long the back light stays on after a
period of inactivity.
Trap Status
Diagnostic tests for Long Range LLC use only.
16
3
Target Management
Target Management o󰀨ers two options, Add Targets and Clear Target Count. The Add Targets
option allows you to specify how many targets are available to be red. Each time a user res
a target, the target count decreases accordingly until it reaches zero. Once the Target Bank
hits zero, the MT4300-C will no longer re targets. If users attempt to launch targets with no
targets loaded into the Target Bank, they will get a message that says, “Target Bank Empty”.
There are 2 ways to rectify this. First, add more targets to the Target Bank through the Target
Management menu. The second option, is to go into the Clear Target Count option in the
Target Management menu and press enter. This will return the MT4300-C to the default mode
of being able to throw targets freely while the unit counts the targets. Clear Target Count also
displays the total amount of targets red in the life of the unit and the current amount of targets
that have been red since the last reset. The total number may not be reset, but the current
number may be reset to zero by pressing ENTER.
The message format may be set to 3 or 4 byte. The default message format is 4 byte. To change this,
from the Set System ID Menu, press 2 to select Msg Format. Press the 1 button for 3 byte, or press
the 2 button for 4 byte. Press BACK to save.
1
2
Set System IDs
RF Channel
Msg Format
1
2
Message Length
3 Byte
4 Byte
It is now possible to set the channel/frequency and trap number on the R4300 Receiver without using
dip switches. This is done with Link Mode which is found in the Set RF Channel Menu. This process
is discussed in detail on the following page (&17).