Long range MT4300-C - Wobble Control Functions; Selecting Wobble Control Option; Choosing Wobble Traps for Control; Using Wobble Trap Nudge

1
2
Select Option 1, Wobble Control
The Wobble Menu gives you two options,
Wobble Control and Wobble Setup. Press
button 2 to select the Wobble Control option.
Select Wobble Trap
The Wobble Control Menu shows the four
wobble traps and their corresponding trap
numbers. Select which wobble trap that you
would like to control using the 1-4 buttons.
Wobble Menu
Wobble Control
Wobble Setup
1
2
Wobble Trap 31
2
3
4
Wobble Trap 5
Wobble Trap 0
Wobble Trap 0
Wobble Control
Nudge
Nudge will energize either the vertical or
horizontal motors for 0.5 seconds and move
the trap in very small increments. Press button
1 repeatedly to move the trap to the desired
vertical position. Press button 3 repeatedly
to move the trap to the desired horizontal
position.
On/O󰀨
Wobble functions can be turned on or o󰀨,
which causes the wobble trap to continuously
move vertically and/or horizontally. Press
button 2 to cycle the continuous vertical
movement on or o󰀨. Press button 4 to cycle
the continuous horizontal movement on or o󰀨.
An “Asterisk” * will appear to the right of the
option if the wobble function is on.
Vert. Nudge1
2
3
4
Vert. On/OFF
Horz. Nudge
Horz. On/OFF
Vert. Nudge1
2
3
4
Vert. On/OFF
Horz. Nudge
Horz. On/OFF
*
3
4
12