www.longer3d.com info@longer3d.com
Question 4: What should I do if I cannot resume printing after
power shutdown?
Question 5:
When the machine is leveling, the nozzle moves to the
left, it can be leveled normally. When the nozzle moves
to the right, it is found that the distance between the
nozzle and the heated bed are very far or very close. If
the spring is adjusted to the extreme position, it still
cannot be leveled. What should I do?
If the power is suddenly turned off when the part is first printed, the machine
will not save the print data. Unless the height of the print exceeds 0.5mm, the
power failure will be supported. If the height is less than 0.5mm, it is
recommended to reprint directly.
If this happens, the X-axis beam is generally loose. At this time, the
hex socket on the right side of the machine can be adjusted with a
wrench to adjust the tightness.
To Next Page
Loading...
