17
5.
5.
5.
5. Safety
Safety
Safety
Safety problems
problems
problems
problems during
during
during
during repair
repair
repair
repair and
and
and
and
maintenance
maintenance
maintenance
maintenance
1)
1)
1)
1) Maintenance
Maintenance
Maintenance
Maintenance place
place
place
place
• The maintenance place should be
equipped with supply maintenance
equipment s.
• This place should be horizontal ground.
• This place sh ould be well ventilated.
• This place should be equipped with
fire-extinguishing device s .
2)
2)
2)
2) Cautions
Cautions
Cautions
Cautions before
before
before
before maintenance
maintenance
maintenance
maintenance
Caution
Caution
Caution
Caution
• No smoking.
• Wear the protective articles .
• Remove the residue oil timely.
• When the lubrication grease is filled,
firstly remove the dirt oil or dust on the
joint or the nozzle tip with brush or
cloth, then fill the lubrication grease.
• Except that maintenance demands, the
key switch should be close.
• When maintain the forklift, the fork
sh ould be lowered on the ground.
• Clean the electrical element with
compressed air.
3)
3)
3)
3) Cautions
Cautions
Cautions
Cautions for
for
for
for repair
repair
repair
repair and
and
and
and maintenance
maintenance
maintenance
maintenance
Caution
Caution
Caution
Caution
• Don't put foot under the fork and do not
be stumbled by the fork.
• When the forklift is raised , the cushion
block or other material sh ould be put
under the in ner mast to prevent the fork
and mast falling suddenly.
• The bottom plate and battery box cover
plate sh ould be opened and closed
carefully to prevent the finger being
injured.
• When the work can't be finished at one
time, symbol shall be marked so as to
finish the work continually.
• Use proper tools and do not use the
substitutive tool.
• Because the pressure of hydraulic circuit
is very high, maintenance can not be
started before reducing the internal
pressure of oil circuit
• Do not use the mast assembly as the
ladder.
• Before repairing and maintaining the hot
machine, be careful that the temperature
of hydraulic system may be higher, so
wait for the machine cooling down to
avoid scalding suddenly.
4)
4)
4)
4) Check
Check
Check
Check and
and
and
and replace
replace
replace
replace the
the
the
the tire
tire
tire
tire
Caution
Caution
Caution
Caution
• The tire should be assembled and
disassembled by specialized staff.
• Do wear goggles w hen the compressed
air is used .
• When charging the tire, inspect whether
the locking ring of rim is equipped.
Improper assembly of the locking ring
may cause accidents.
To Next Page
Loading...
Need help?
General
