Lonking LG20D User Manual

45
Caution
Caution
Caution
Caution
• Please use the gangway with sufficient length, width and strength.
• Effectively pull up the parking brake of freight vehicle and brake the wheel.
• Fix the plate in the middle of the trunk reliably and the gangway shall be free from grease.
• The right and left height of gangway shall be same so that the vehicle can be stable when
it ’ s loaded and unloaded.
• In order to prevent danger, the forklift can ’ t be turned or moved laterally on the gangway.
• When the forklift is moved to the freight vehicle, the right and left tires shall get on the
gangway slowly.
3) Lift forklift
• Only use the crane and the rope which can bear the goods weight
• Tighten the steel rope to hoisting holes at the both ends of outer master beam and the hook
on the balancing weight. The steel rope connected to the balancing weight should pass
through the gap of the overhead gap. Do not let the overhead guard be under stress.
• If it is necessary, use the edge protector to protect the equipment and prevent the machine
from being damaged.
• Conform the center of gravity for the forklift.
• Make sure the forklift is balanceable.
6
6
6
6 .
.
.
. Before
Before
Before
Before and
and
and
and after
after
after
after the
the
the
the engine
engine
engine
engine startup
startup
startup
startup
1 ） Before the engine startup
• Before operation, inspect whether operations of all control devices and alarm devices
are normal. If the device is damaged or the device is abnormal, do not start the forklift
until the failure will be removed.
• Inspect the safety condition around the forklift.
• If there is grease or oil adhering to the bottom plate, the pedal, control lever or the
hand of the operator, clean it out.
• Make sure the shifting lever and the multi-way lever are at the neutral gear, and the
parking brake lever should be at the brake condition.
• Start the diesel engine.
Turn the preheat starting switch to"ON" until the preheat display indicating lamp is off. Then
turn the preheat starting switch to "START" position. If it is difficult to start the engine, check
whether the fuel level is too low, whether the air comes into the fuel system , or whether the
preheat wire is broken.
2 ） After the engine startup
• Preheat the engine(about 5minutes)
• Inspect the sound of engine(rotation or the gear)

Lonking LG20D Specifications

General

Brand	Lonking
Model	LG20D
Category	Forklifts
Language	English