Lonking LG20D User Manual

51
10.
10.
10.
10. Un-stacking
Un-stacking
Un-stacking
Un-stacking
The goods shall be un-stacked according to
the following procedures:
(1) Speed shall be reduced when
approaching the goods.
(2) Park the forklift before the goods
(goods are 300mm from the tip).
(3) Regulate the forklift position before
the goods.
(4) Ensure goods are not overloaded.
(5) Mast is vertical to ground.
(6) Observe the fork position and drive
forklift forward simultaneously until the
fork is inserted into the pallet.
Note
Note
Note
Note
When
When
When
When the
the
the
the fork
fork
fork
fork can
can
can
can ’
’
’
’ t
t
t
t be
be
be
be inserted
inserted
inserted
inserted into
into
into
into the
the
the
the
pallet
pallet
pallet
pallet completely:
completely:
completely:
completely:
a. Insert 3/4 fork and raise the pallet a
little (50~100mm), take out the pallet
about 100~200mm and then lower
pallet;
b. Insert the fork into the pallet
completely.
(7) After the fork is inserted into the pallet,
raise the pallet (50~100mm).
(8) Observe surrounding area and drive the
forklift backward until the goods are
lowered.
(9) Lower the goods until it ’ s 150~200mm
above ground.
(10) The mast tilts back to ensure goods are
stable.
Transport the goods to destination.

Lonking LG20D Specifications

General

Brand	Lonking
Model	LG20D
Category	Forklifts
Language	English