Look Solutions Tiny CX - Battery Safety Regulations

12
6. The Battery
6.5 Fuse
–Keepawayfromchildren
–Donotheatupover140°F(forexamplebysunexposure)orexposetore
–Keepawayfrommoisture
– Do not short-circuit
– Do not dismantle or deform
– Do not use defective or deformed battery-packs
Batteries can leak or be damaged if used incorrectly.
In some extreme cases, there is danger of:
– Fire
– Explosion
– Smoke- and gas exposure
In this event, please note:
– If there is no suitable extinguisher available, let the battery burn down and
avoid breathing the fumes
– To extinguish the fire use sand or a fire extinguisher filled with powder only
Toavoidovercurrent,thebatteryisequippedwitha7.5AMiniblade-fuse[7].This
fuse has to be replaced if it blows.
6.6 Safety Regulations
Avoid complete discharge (control-LED does not light at all) because this will cause
irreversible damage to the battery.
Lithium-Ion batteries must only be recharged and stored on fireproofed and non-
flammable surfaces! The battery must not be recharged unsupervised.
Theambientoperatingtemperaturewhilechargingshouldbebetween50°Fand
105°F.
When the battery is fully charged, the Charge-LED will extinguish or change its colour,
depending on what type of charger is delivered.
– Disconnect the charger from the battery.
Recharge the battery of the Tiny CX after each use, or, when the yellow control-LED
inthemachineslid[5]ashesfast,rechargeimmediately.