9
5. Operating the Unique
2
From the finest mist to a thick haze, similar to fog, any desired effect can be
achieved. These haze effects form slowly so that the device should be switched
on some time before the lighting or the laser start to operate.
Important: Do not connect a ducting to the nozzle of the Unique
2
. If a ducting
is connected directly to the machine the haze will be pushed back into it. This
may damage the machine. We cannot grant warranty in this case!
5.1 Selecting the location
The location in which the Unique
2
is to be operated must
– be dry,
– be free from dusty or polluted air,
– be free from vibrations,
– be a non-flammable place or surrounding,
– be well-ventilated with haze-free air keeping the ambient operating tempera-
ture between 50° F and 105° F and the relative humidity below 80%.
5.2 Putting into operation
Warning: Never connect the Unique
2
to a dimmer or switchpack! This may destroy
the machine.
a. Connect the power plug to an electrical outlet.
Make sure the outlet has the correct voltage for your
machine.
A P and two figures appear on the LED display [17].
b. After 60 Seconds, the Unique
2
is heated up. Press the Enter button [16] once to
start the haze process. The green Active LED [18] will be lit. After a short delay
the machine begins to haze.
After 30 Seconds the display will go dark. To re-activate it, press one of the
buttons on the display.
To Next Page
Loading...
