LORCH P-Basic - Service Codes

Troubleshooting
- 63 -02.20 909.2710.1-06
9.14 Service Codes
Via menu Extras, Lock function special Service codes can be entered to enanble or disable different func-
tions.
code function displayed message
644 reset the three-digit code of the lock function to “000” Code = 0
660 activate TIG mode selection TIG mode On
661 deactivate TIG mode selection TIG mode Off
663 deactivate PE protection PEC control Off
664 activate PowerMaster buttons Powermaster On
665 deactivate gas pressure switch monitoring Gas monitor. Off
666 deactivate PowerMaster buttons Powermaster Off
668 activate +/- 10% correction at Tiptronic with lock level 2 or 3 PlusMinus10% On
669 deactivate +/- 10% correction at Tiptronic with lock level 2 or 3 PlusMinus10% Off
670 activate US units US units On
671 deactivate US units US units Off
Entering the Codes
– enter menu Extras, Lockfunction
– press button material (minus) or button gas (plus)
– acknowledge the question „Change Parameter?“ with button “arrow up”
– press button minus or plus
– enter the code number with the encoder of the front panel
– acknowledge with button “arrow down”