Front panels
- 13 -02.20 909.2710.1-06
Master Reset
– press the buttons “arrow up” [1] and “Mode” [3] together for about five sec.
– the display shows “Master Reset“
– the machine is reset completely to factory settings
!!! CAUTION !!!
all Tiptronic jobs are deleted after a Master Reset!
Before a Master reset is done, it is important to check if Tiptronic jobs are present on the ma
-
chine. If necessary make a safety copy of the jobs using the PC software “JobTool”.
Menu Extras
– press both buttons “arrow up” and “arrow down” [1] at the same time
– use the buttons “material type” (-) [4] and “gas type” (+) [2] to switch between the menu items
forth and back
– press both buttons “up” and “down” [1] again to go into the selected menu item
– press the middle button “wire diameter” (End) to go back to the previeous menu level
Menu Customizing
– press the buttons “arrow up” [1] and “wire diameter” (End) together for about five sec.
– use the buttons “up” and “down” [1] to switch between the menu items forth and back
– use the buttons “material type” (-) [4] and “gas type” (+) [2] to change the setting
To Next Page
Loading...
Need help?
General
