BERNT LORENTZ GmbH
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, www.lorentz.de
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
Guide for troubleshooting for PS2 pump controller
• Insert the red measuring tip (+) into the
right pin (+) on the LED-Board as shown
in the picture
• Insert the black measuring tip (COM)
into the fourth pin from the right hand
side (GND) on the LED-board as shown
in the picture
• Configure your multimeter
o Choose voltage DC –
measurement
o Insert the test prods into its
provided sockets (black to COM
& red to V DC)
• Remove the protection cap in order to
get a proper contact to the terminal
clamps
To Next Page
Loading...
