BERNT LORENTZ GmbH
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, www.lorentz.de
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
• Remove all additional cables which are
connected to accessories
• Bend the jumper cable up or remove the
jumper cable to secure a proper contact
between the terminal clamp and the
test prods
• Contact with the red measuring tip (+)
the terminal clamp 13 (Water sensor) on
the Power-board as shown in the picture
• Touch with the black measuring tip
(COM) the terminal clamp 15 on the
Power-board as shown in the picture
To Next Page
Loading...
