BERNT LORENTZ GmbH
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, www.lorentz.de
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
Guide for troubleshooting for PS2 pump controller
If the connection between the sensor cables is an open loop, check whether this is a reasonable
result (e.g. Well Probe – check whether the Well Probe is submerged or not). However, if the
sensor gives invalid outputs replace the sensor/cable splice/cable.
• Connect the grabber clip to the Well
probe cable/Remote Switch cable
• Check whether the switch is open or
closed
To Next Page
Loading...
