Follow the steps below to add cameras that are not directly connected to the Power over Ethernet
(PoE) ports on the back of the recorder.
12
Adding cameras from the LAN
To add cameras from the LAN:
1. Connect the camera to a router or switch on the same network as the recorder.
2. Right-click and then click Camera Registration.
3. Enter the system user name (default: admin) and password.
4. Congure the following:
a. Check the camera(s) you would
like to add.
b. Click Add. The status indicator
turns green to show the camera
is successfully connected.
c. The added device(s) will appear
in the Added Device list.
d. If the icon in the Status column
appears red, there may be a
password issue with the camera.
Select the camera and click
Reconnect IPC.
a
b
c
d
To Next Page
Loading...
Need help?
General
