116
repeat until the name is correct, then press
ENT|ENT. B. Or you can
jump down to the lower box and pick a street from the selection list.
Press
ENT, then press ↓ or ↑ to select a street from the list and press
ENT.
3. The Find Streets menu reappears with the street you're searching
for in the First Street box. (In this example, it's 80th Street.)
4. Now fill in the second street. Press ↓ to
SECOND STREET|ENT and the
Find By Name menu appears again. Just like before, there are two op-
tions:
A. You can spell out the second street in the top selection box. Press ↑
or ↓ to change the first letter, then press → to move the cursor to the
next letter and repeat until the name is correct, then press
ENT|ENT.
B. Or you can jump down to the lower box and pick the second street
from the selection list. Press
ENT, then press ↓ or ↑ to select a street
from the list and press
ENT.
5. The Find Streets menu reappears with the first and second street
dialog boxes filled in. In this example, we selected 71st Avenue as our
second street. You could now use similar techniques to select a city or
Zip code, but your search will probably be faster if you leave those
boxes blank. You can specify a city and/or Zip code later on to narrow
the search, if the resulting list is too long.
Find Intersection command highlighted, left, and
"Working" message, center. At right is the Intersections Found list.
6. To search for the intersection of the two streets, press ↓|→ to FIND
INTERSECTION|ENT. A message appears asking you to wait while the unit
finds the intersection. When the Intersections Found list appears, press
↑ or ↓ to select the intersection you are searching for and press
ENT. In
our example, we selected the intersection of SW 80th Street and SW
71st Avenue in Miami, Fla.
To Next Page
Loading...
Need help?
General