Chapter 5 High-speed Link Setting
5-7
1) How to use High-speed link window
Parameter is specified at High-speed link window as shown below. There are 2 kinds of
parameter setting, Communication module setting and High-speed link block setting.
Communication module setting
High-speed link block setting
High-speed link1 [B0S0 Rnet] is as shown below.
1) High-speed link1: It is a serial number of High-speed link.
2) B0: It means Base number 0. (Example: Expansion base 2 stage - B2, Expansion base 5 stage - B5)
3) S0: It means Slot number 0. (Example: Slot number 5 - S5, Slot number 11 - S11)
To Next Page
Loading...