LS ELECTRIC XGT Series - Page 38

Chapter 5 High-speed Link Setting
5-9
3) Parameter of High-speed link block setting
High-speed link block setting parameter is as shown below.
Block window
-
Item
Description
Module type
1.DC input 16points
GRL-D22A/D22A(N)
2.DC input 32points
GRL-D24A/D24A(N)
3.TR output 16points
GRL-TR2A/TR2A(N)
4.TR output 32points
GRL-TR4A/TR4A(N)
5.Relay output 16points
GRL-RY2A/RY2A(N)
6.DC input 16 points/output 16points
GRL-DT4A/DT4A(N)
7.GM3,GM4,GM6,PMU
GM3/4/6L-RREA, PMU
-
Station type
Auto-setting when module type is set.
Mode
Auto-setting when module type is set.
Station No.
Slave station number (range: 0 ~ 63)
Read area
(Master module

Slave module)
Address
XGK
Head address of transmitting device.
Usable device: P, M, K, F, T, C, U, Z, L, N, D, R, ZR
XGI
Head address of transmitting device.
Usable device: A, M, I, Q, R, W, F, K, L, N, U
Size(Byte)
Input/Output point of slave module is displayed in Byte.
- If input module point is less than 8 bit, it is dealt with 1 Byte.
Save area
(Slave module

Master module)
Address
XGK
Head address of receiving device.
Usable device: P, M, K, F, T, C, U, Z, L, N, D, R, ZR
XGI
Head address of transmitting device.
Usable device: A, M, I, Q, R, W, F, K, L, N, U
Size(Byte)
Input/Output point of slave module is displayed in Byte.
- If input module point is less than 8 bit, it is dealt with 1 Byte.
The priority order of data is the slave module which has lowest station number.
Unit of address setting is Word. But slave module’s unit size is Byte. Less than 8 point module is
processed by 1 Word when address is specified.
Remark
Select by mouse then
module type setting
screen is opened as
shown below.