Chapter 4 Operation Procedures and Monitoring
4-8
3) Select the applicable module and click the monitoring button to display the monitoring/ test screen as shown
below, whose functions are as follows;
• On the upper monitoring screen, each special module’s monitoring item values are displayed.
• On the bottom test screen, each module’s parameter items can be changed individually.
If you click TEST button, setting values is applied to current value.
(1) It is applied to only test operation to the parameter which changed by Test button. If test operation is
concluded, the high speed counter module is operated by the parameter which was set by I/O parameter or by the
scan program.
(2) If PLC CPU module is STOP mode, it is available to test operation and monitoring function.
But in case of RUN mode, it is available only to monitoring function.
Remark
To Next Page
Loading...