Chapter 7 Programming
7-21
7.2.8 Up/down count selection
Program example selecting UP/Down count when input pulse is set as 1 phase 1 input 1 mutiplication/2 multiplication
1. Program
(a) Scan program of XGK series
(b) Scan program of XGI/XGR series
7.2.9 Use of external preset signal
Program examples allowing Enable preset by external preset signal and executing reset when external preset signal is detected
1. Program
(a) Scan program of XGK series
(b) Scan program of XGI/XGR series
To Next Page
Loading...