LOADER REMOVAL
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
CAUTION:CAUTION:
CAUTION:
Tip the bucket until the bucket cutting edge
touch the ground.
▶
▶▶
▶
Pull the control lever to raise the loader until
the post.
Adjust the bucket until the bottom surface of
bucket touch the ground.
▶
▶▶
▶
Move the tractor backword slowly and stop
to avoid the hydraulic hoses being tighten.
Never park loader without bucket
attached to the loader.
Never allow weight of tractor to be put
on parking leg when removing loader.
▶
▶▶
▶
Park the tractor and loader on hard level
surface.
▶
▶▶
▶
Raise the boom until the bucket is about 2
feet off the ground.
▶
▶▶
▶
Set the parking legs with pin-hand and
Keeper.
▶
▶▶
▶
Lower the boom until the Parking legs
make contact on the ground.
- 15 -
▶
▶▶
▶
Remove the latch pin while move the
control lever back and forth slightly to make
the latch pin easy.
back and forth, left and right several times to
reduce the hydraulic pressure in the hoses.
▶
▶▶
▶
Disconnect the quick couplers on the
hydraulic hoses.
PIN
PINPIN
PIN
STAND
STANDSTAND
STAND
PIN
PINPIN
PIN-
--
-HAND
HANDHAND
HAND
- 15 -