4 -28
PRE-OPERATION CHECK, REAR BALLAST !
▶ For tractor stability and operator’s safety, rear ballast should be added to the rear
of the tractor in the form of implements as counter weight like Back Hoe, Rotary
Tiller, etc. The amount of rear ballast will be depend on the application.
Caution
② Connection of hydraulic hoses
To install the front-end loader and connect its
hydraulic lines, contact your authorized local
dealer.
After connecting the hoses, start the engine and
check the leakage of the hydraulic lines.
Operate 2~3 times fully all the hydraulic
actuators on a newly attached front implement to
exhaust air from the system.
After lowering the front implement, check if the
transmission oil level is marked between “Min”
and “Max” scale on the oil gauge. If necessary,
add new oil.
<Oil gauge >
Max.
Min.
Oil gauge
Oil filling inlet
To Next Page
Loading...
Need help?
General
