LS tractor MT2 Series - Checking Transmission Oil; Checking Front Axle Oil

5 -27
Oil gauge
(3) Checking Transmission oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around the oil filling inlet and pull the
gauge straight out.
 Check If the oil level is between MAX and MIN of
the oil gauge. If necessary, add new oil.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
▶
The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the transmission and hydraulic system. Clean around the oil filling
inlet before opening the gauge.
Caution
(4) Checking Front axle oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Unscrew the oil gauge and pull it up.
 Check If the oil level is between maximum and
minimum marks of the oil gauge.
 If necessary, add new oil into the oil filling port.
(after 5~10 minutes later, check it again)
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil gauge
▶
The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the front axle. Clean around the oil filling inlet before opening the
gauge.
Caution