4 -8
(5) Stopping tractor
HST Type
PTO switch
Caution
▶ DO NOT leave the tractor when the transmission gear is placed in neutral position
and the parking brake is not applied. The tractor may roll down. Apply the parking
brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
1. Release the HST pedal slowly and pull the
throttle lever to “Low” speed position. Place
all the transmission gear levers in neutral
position and put PTO switch in “OFF”
position.
3. Apply the parking brake after pressing brake
pedals, and release the brake pedals slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position..
PARK
Brake pedals
Key switch
Parking brake
lever
Brake pedals
Throttle lever
HST pedals
To Next Page
Loading...
