LS tractor MT2 Series - Turn Signal Light Bulb - Replace

5 -52
(5) Turn signal light bulb - Replace
①
Turn signal light bulb replacement
1. Remove the four screws
①
retaining the turn
signal light lenses and remove the lenses.
2. Push in on the bulb
②
and rotate bulb counter-
clockwise in socket to remove.
3. Insert the new bulb into the socket and turn it
clockwise until the bulb locks into place.
4. Install lenses and retaining screws.
NOTE: For about bulb specification, refer to the
chapter 5-5-(4) in this manual.
1
2