5 -53
(6) Headlight bulb - Replace
①
Headlight bulb
If a headlight bulb
①
fails to operate, the bulb
must be replaced as below.
1. Open the tractor hood.
2. Remove the harness connector.
3. Rotate the bulb
①
counter-clockwise a quarter
turn and remove the bulb from the housing.
4. Insert a new bulb into the socket and turn 1/4
turn clockwise to secure.
5. Reinstall the harness connector.
NOTE: For about bulb specification, refer to the
chapter 5-5-(4) in this manual.
▶
Be careful not to touch the bulb with bare fingers. Oil from the fingers can shorten
the life of bulb. Use protective cloth or glove when installing bulb.
▶
Bulb and surroundings are very hot while working. Be careful not to touch the bulb
with bare fingers. It may cause a burn of your hand. Before servicing the bulb, turn
off the light and cool down the bulb.
Caution
1
To Next Page
Loading...
