5 -43
②
Bleeding the injector lines (if necessary)
▶
Escaping fluid!
Hydraulic fluid or diesel fuel leaking under pressure can penetrate the skin
and cause infection or other injury. To prevent personal injury: Relieve all
pressure before disconnecting fluid lines or performing work on the
hydraulic system. Before applying pressure, make sure all connections are
tight and all components are in good condition. Never use your hand to
check for suspected leaks under pressure. Use a piece of cardboard or
wood for this purpose. If injured by leaking fluid, see your doctor
immediately.
Failure to comply could result in death or serious injury.
Warning
Bleed the injector lines if:
The tractor has run out of fuel.
New injectors have been installed.
The injection pump has been removed for
service repairs.
To bleed the injector lines:
1.Loosen the injector line fittings
①
at the
injectors.
2.Move the hand throttle control lever to its wide
open position.
3.Crank the engine until air-free fuel flows from
each connection, then tighten the fittings to
29~34 N·m (22~25 lb ft).
NOTICE: If air is not purged from the system,
repeat the above procedures. Do not crank the
engine continuously for more than thirty seconds,
as this may cause starting motor failure.
1
To Next Page
Loading...
Need help?
General
