3 -42
(9) Four wheel drive lever (4WD)
This lever is used to engage/disengage the four
wheel drive (4WD). Pull it upward for engaging
4WD.
Before operating the 4WD lever, press down the
clutch pedal, brake pedal, and stop the tractor
completely.
4WD is very effective in the following cases.
- When increasing the towing power for heavy
work.
- In case of working in sandy soil.
- To prevent tractor from spinning in wet land.
Four wheel
drive lever
4WD
2WD
(10) Middle PTO lever (if fitted)
It is used to engage/disengage the middle PTO
gear.
Before operating the middle PTO lever, put PTO
switch to “OFF” position and stop the PTO shaft
completely.
Pull the middle PTO lever up to engage the
middle PTO gear.
For further information about the middle PTO
shaft, see chapter 4-5-(2) in this manual.
Middle PTO lever
ON
Differential
lock pedal
(HST type)
▶ When driving on public road, disengage the 4WD. If not, it may cause damage of
transmission drive line and serious accident. After working in the field, select the
2WD.
▶ While driving at high speed with the 4WD is engaged, sharp steering may cause
an accident.
▶ Only operate four wheel drive lever by hand. If stepping on it , it may cause a
failure.
Caution