LS tractor MT335 - Drivers Seat (HST Type)

2 -4
(2) Driver’s seat (HST type)
 At the lower end of the seat, there is a switch to
detect that operator is sitting in the driver’s seat.
 If the operator gets up from the seat while
engine is running, the engine will stop
automatically for safety in case of ;
① getting up from the seat for more than 2
seconds with HST pedal NOT in neutral position.
② the HST pedal is in NEUTRAL and rear PTO is
engaged without applying the parking brake.
③ the Middle PTO lever (optional) is engaged.
Seat switch
Seat switch
 Before leaving the driver’s seat, turn the PTO
switch to the “OFF” position and place the Middle
PTO lever (if fitted) in the “OFF” position, and
apply the parking brake.
ROLL-BAR
CABIN
warning
▶Do not arbitrarily remove the seat switch. When replacing the seat, make sure to
check if the seat switch is correctly in place. If not, the engine can not be started.