4 -2
(1) Engine start
Mechanical type
1. Sit in driver’s
seat and apply
parking brake
2. Place main gear shift, range gear
shift lever, shuttle lever in NEUTRAL
and PTO switch in “OFF” position.
3. Pull the throttle lever to
the low speed position.
8. Run the engine for a
few minutes to allow
engine oil and
transmission oil to warm
up.
7. Check if the battery charging
indicator and engine oil
pressure indicator are OFF
after starting engine.
If not, stop the engine
immediately and check the
problem.
Clutch pedal
Brake pedals
Throttle lever
PTO switch
Key switch
F/R shuttle lever
Throttle pedal
6. Depress clutch pedal
fully and turn key switch
to “START” position. As
soon as the engine
starts, release the key
switch to “ON” position.
5. Wait until the cold start
aid indicator is OFF.
(about 10 seconds)
4. Turn key switch to “ON”
position and check if the
battery charging
indicator, engine oil
pressure indicator and
cold start aid indicator
are ON.
Caution
▶Check each part before starting
engine.
▶Check if there are any other
people around before starting.
▶Place all the transmission gear
levers and switches in
NEUTRAL or “OFF” position.
4-2. Engine Start and Stop
To Next Page
Loading...
