4 -8
HST type
1. Lift up all the implements (front/middle/rear)
from the ground after starting engine.
3. Press down the brake pedals and place the
range gear shift lever on a suitable position.
4. After pressing down brake pedals, release
the parking brake lever.
5. Press the HST forward/reverse pedal down
slowly. If necessary, press down the cruise
control switch for constant forward speed.
Release
Range gear shift lever
Parking brake lever
Brake pedals
HST
reverse
pedal
HST
forward
pedal
Cruise control switch
2. Set the engine speed more than 1500
rev/min.
▶ If pressing the brake pedals or turning off the cruise control switch, the cruise
control drive will be stopped.
▶ For HST models, there is a switch on the driver’s seat to control the engine cut-off
system for driver’s safety. If you leave the driver’s seat without safety measures,
the engine will be stopped automatically. (For the details, see chapter 2-1-(2))
▶ When driving or working with a HST model, run the engine at 1500 rev/min or
higher to maintain the hydraulic system stable.
▶ Operate the HST forward/reverse pedal slowly to prevent a sudden start or stop.
Caution
To Next Page
Loading...
