4 -40
Heavy parts!
▶The ballast weights are very heavy. When removing/attaching the ballast weights,
please be careful and use a suitable hoist and specific equipment to move the
heavy parts. Failure to comply could result in death or serious injury.
Warning
② Rear ballasting weights (optional)
- Rear wheel weights (Optional)
To remove the rear ballast weights, connect the
bumper to the suitable hoist, and unscrew the
bolts in the right figure and disassemble the
weight plates one by one if necessary.
Rear weight (kg) : 45kg x 2ea = 90kg or
45kg x 4ea = 180kg
When assembling the ballast weights, comply
with the reverse procedure of the disassembly.
For additional ballast weights and adjustment
methods, contact your authorized local dealer.
- Rear ballast weights on the 3-point
linkage
To mount the ballast weights on the rear of the
tractor, an additional weight bracket must be
installed on the rear three-point hitch.
Contact your authorized local dealer for the
bracket.
If you hard to get the bracket, you can use a
equivalent weight rear implement as the
ballasting weight.
Rear ballast weight
Connectors Bolts
To Next Page
Loading...
