5 -25
Clutch pedal
(10) Adjustment of Clutch pedal
play
① Synchro-shuttle (Mechanical)
Normal distance: 20~40mm (0.8~1.6 in.)
If the distance is over the normal distance, adjust
it as below.
1. Loosen locking nut and turn the clutch rod
clockwise / counter-clockwise.
2. If tightening the clutch rod, the pedal play shall
be increased, and if loosening, it shall be
decreased.
3. Pay attention that the clutch rod does NOT push
the piston of clutch master cylinder when the
clutch pedal is released.
4. After adjusting the pedal play, tighten the locking
nut.
5. Check if the clutch is disengaged completely.
Clutch rod
Lock nut
If you need more adjustment for clutch pedal play,
check the oil level and bleed air from the clutch
pedal oil line. (See page 5-50)
② Power shuttle (PSS)
In case of power shuttle models, an electric
sensor to control the power shuttle clutch pack is
attached and tuned specially on the clutch pedal
linkage system.
If this linkage system is changed or modified
arbitrary, it may cause a serious fault or
malfunction to the power shuttle clutch pack.
The air-bleeding of the power shuttle clutch
pedal system is NOT needed.
If you need any service for power shuttle system,
do not hesitate to contact your authorized local
dealer for check.
To Next Page
Loading...
